NOTE: Apply slow and steady pressure, when you turn the filter. NOTE: If the arrow and padlock line are not lined up, the water will not flow into the dispenser. The Lock symbol looks like a closed padlock. The turning may be difficult.ĥ) Put the water filter into the water filter holder so that the Unlock symbol on the water filter lines goes up above the Water Filter mark on the filter holder.Ħ) Turn the water filter counter clockwise 90 degrees until the Lock symbol on the water filter lines goes up above the Water Filter mark on the filter holder. Apply a slow and steady pressure when you turn the water filter. The Unlock symbol looks like an open padlock. To change the water filter, follow the steps below:ġ) Make sure that the water line connected to your refrigerator is turned off when the refrigerator water line is connected to the water supply house.Ģ) If your water filter holder is located in the upper right rear of your refrigerator, remove the top glass shelf from your refrigerator.ģ) If your water filter holder is located behind the vegetable bin, remove the vegetable bin from your refrigerator.Ĥ) Remove the old water filter by turning it counter clockwise 90 degrees, until the Unlock symbol on the filter lines goes up above the Water Filter mark on the filter holder. In the upper right rear of the refrigerator.The water filter is located in one of the two places below in your refrigerator: If the water filter is not correctly installed, it can block the water flow into the dispenser. To turn on the water line, follow the below steps:ġ) Carefully pull the refrigerator away from the wall.Ģ) Locate the water connection on the back of the refrigerator.ģ) Trace the line to a point where it is connected to the water supply house.Ĥ) Find the small shut-off valve at the connection.ĥ) Open the valve and turn on the water line. You need to flush the water system to remove air (bubble) inside of the water line.Īir can go into the water line due to a bad water connection. To clear air out of your water line, press the water dispenser lever for one or two minutes. To fix the above conditions and get the water dispenser to work again, please do the followings: Water tank inside of the fridge compartment is frozen.Tube fitting at the bottom (RSG* Model) is wrongly installed.Your water filter cartridge needs to be replaced.Your refrigerator water line is not turned on.Bad water connection ( Bad Plumbing/Water line kink/Bad fitting connection of tube).The failure of a water dispenser is generally caused by one of the following conditions: No ice production (No water comes into the ice tray.) Water leaks from the freezer compartment (See step 4 below.)Ģ.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |